Although I teach three Tailoring Ready-to-Wear classes on Craftsy, there are a few alterations that many students ask about that were not included in the classes. One of the most common questions: “How do I hem pants with a cuff?” Hemming cuffed pants is very simple, but its important to pay attention to the measurements or you run the risk of hemming the pants too short.
There are so many sewing products on the market, it can get overwhelming trying to decide which ones to try. Here is one for you … Hug-Snug Seam Binding. Take a look inside some of your nicer pants and skirts, you will often see a rich looking ribbon covering the hem allowance edge. Hug-Snug is probably the ribbon you see. This ribbon is 100% Rayon, has a satin finish and it comes in a TON of colors.
The edge of the fabric should land in the middle of the ribbon. Stitch along the edge of the ribbon. (I am using contrasting color ribbon and thread so it’s easier to see :))
The above photo shows the single stitch line and how the ribbon covers the fabric raw edge.
Stitch just past the starting point …
… fold under the end of the ribbon, enclosing the raw edge of the ribbon.
Turn the fabric and stitch the folded edge of the ribbon in place.
The ribbon is attached, covering all raw edges. Hem the garment as usual, using the edge of the ribbon as the hem allowance edge. The ribbon is so much thinner than fabric and really makes a perfect blind hem! Below I am using a blind hem machine:
Notice how the ribbon edge is connected to the garment, finishing the hem. If using the blind hem stitch on a sewing machine or hand-stitching the hem in place, do the same thing; connect the edge of the ribbon to the fabric.
I told you it’s easy! Again, Hug-Snug Seam Binding comes in a ton of colors:
How are the jeans coming along for the wardrobe challenge? Don’t forget to upload your photos to the Flickr group, there are some really cute outfits showing up 🙂